Pag 20/
30
I SBG-Side-Shift-IM-EN-V1.1
SBGuidance Side-Shift I Version 1.1 I CAN
3. Configuration and calibration
The following software and firmware versions
are required for the set-up, calibration and use
of the CAN Side-Shift controller:
CAN-Tool 1.28 or more recent version.
Side-Shift steering firmware
STU_Side-
Shift_2.0.30
or more recent version
SBGuidance 3.8.2 or more recent
version.
Check the download page on
and firmware versions.
View Configuration manual
– CANbus
controllers for updating a steering
controller.
3.1. Configuration CAN-Tool
Startup the CAN tool. At Hardware, choose
manufacturer “
Viper 4
” in case of a Viper4
terminal and “
SBG
” in case of a GeoSTAR
terminal and press on
Initialize
.
After initializing the connection with the CAN
bus, a bus load must be displayed. Received
frames must be in increasing increments. The
bus load and received frames are displayed at
the bottom of the screen. If this is not the case,
check the lead connections.
Go to the tab page MyDevice (Figure 16) and at
Pre-
selection select “
Navigation Controller
(Implement)
”. Then press “
Connect
”.
Go to the tab page MyPartners (Figure 17). At
Implement Controller press
“
Add
”. This will
Figure 16 CAN-Tool MyDevice Implement Controller
Figure 17 CANTool Mypartners Implement Controller
