Raven Hawkeye Operation Manual Download Page 25

Page: 25 / 138

System Calibration: Initial Start Up and Calibration Wizard

SYSTEM CALIBRATION

6. Select the Tip Size field and use the available options to select the orifice size of the tips currently installed on

the nozzle bodies.

•

NCV is the tip connected to the Hawkeye

valve. The Bypass Tip is for secondary tips at each

nozzle.

•

If no tips are installed and liquid fertilizer is being applied, select NA as the tip size.

7. Select the Next button to proceed to the Nozzle Indexing prompt.

AUTOMATIC NOZZLE INDEXING

The automatic nozzle indexing process allows the Hawkeye

system to automatically configure the location of

each nozzle control valve on the left and right boom circuits and may detect issues with system connection or

nozzle setup.
1. When prompted, select the Next button to begin the auto-indexing process.
2. Hawkeye

will begin indexing nozzle control valves from the center of the implement boom and move out to

the end of the left boom. The indexing process automatically repeats for the right boom circuit, starting from

the center and working towards the end of the boom. If an error is detected on either the left or right boom
circuits, the Hawkeye

Product Controller II ECU will halt the indexing process and prompt the machine

operator to correct the error before continuing with the calibration wizard. If an error occurs, troubleshoot the

issue and press retry.

FENCE ROW SETUP

Fence row setup is only available if Sprayer was selected as the applicator type. If Applicator was selected, fence

row setup is skipped.
1. The Fence Row Setup prompt will display once the automatic indexing process completes.
2. Enable the fence row option if fence row valves are connected to the system. Select the Enable On Screen

Buttons box to control fence row valves through the on-screen interface. If using secondary input switches to

the boom sense for fence rows, enter the appropriate section input for the left and right fence rows.

3. Select the Next button to continue to the Section Setup prompt.

SECTION AND SWITCH SETUP

1. Select the Number of Sections field and enter the number of section on/off valves available for Hawkeye

section control.

NOTE:

Liquid fertilizer applicators running

Hawkeye

must have a single master valve instead of multiple

section valves. In this case, enter the number of toolbar sections. For example, a toolbar that folds

twice on each side would have five sections (L outer, L inner, Center, R inner, R outer).

2. Select the Next button to display the Section Width Setup prompt.
3. Select the Section Width fields and enter the width of each section across the implement. In Applicator mode,

enter the number of Hawkeye

NCV’s in each toolbar section.

a. Section 1 is always the farthest left section on the implement and the highest section number is always the

farthest right section.

b. Measure the width of the boom (or count the number of nozzles and multiply by the nozzle spacing)

controlled by each section and enter the section measurements to ensure that the system accurately

records section coverage during field applications.

c. For liquid fertilizer applicators in Applicator mode, the Hawkeye

NCV’s at each end of the toolbar are

each treated as half a row. For example, an outer section consisting of four nozzle control valves with 30”

spacing would have a section width of 30” + 30” + 30” + 15” = 105”.

4. Touch Next to display the Boom Offset page.