19
4.
Click the “Submit” button and
the page will refresh to look like Figure 6-8.
Figure 6-
8: Once the “Submit” button is clicked, the webpage will be refreshed to show
the
different channels that can be selected for an RTP stream.
5.
Create the RTP channels associated with the Blade-Link by entering a name, the Rx and Tx Ports
to match with the Tx and Rx ports on the VoIP interface, checking the box if COR is required for
the blade-link, and clicking the enable button. *
The RTP Channels does not correspond to the
individual ports. Do not skip unused channels since it can cause problems loading in the
settings during FlexGate restarts. If the checkbox for COR is not checked, it will operate in VOX
mode. This is good for radios that do not provide the COR on the input side of the VoIP
interface, but do require a PTT for the output *
6.
Navigate to the “Patches” page on the FlexGate webpage and add the RTP channel name
s
created with the M4x Blade Audio Channels. *
If you do not have your M4x audio channels
already setup, refer to the FlexGate Comprehensive Guide*
