ERVICE
S
48
6823346-R3
FK0128.eps
3.3
Display
3.3-1
Pairing The Display To iForks
For situations where the dual Bluetooth
®
pc board has been
replaced or the complete display is replaced, it is necessary
to pair the display to each of the iForks Bluetooth
®
receivers.
Example using a PDA:
FK0129.eps
1
Determine the MAC address for each iFork receiver.
• Option 1 –
Locate MAC address sticker.
Early Models –
If the complete display was not
replaced, look on the back of the display (some
displays).
NOTE:
Remove display from mounting bracket to find
the mac addresses.
IMPORTANT:
If the MAC address sticker is missing,
contact Cascade.
IMPORTANT:
For displays wired directly to the truck
power, disconnect the display from the power source
before opening the display.
Current Models –
Remove the shank cover plate on
each iFork. The MAC address for the iFork is located
on the lower front face of the receiver.
IMPORTANT:
If the MAC address sticker is missing,
contact Cascade.
IMPORTANT:
If iForks are NTEP certified, use Option 2.
• Option 2 –
Use any device that has Bluetooth
®
pairing capabilities: PDA, Mobile Telephone, PC,
Terminal, etc.
IMPORTANT:
The following procedure can not be
performed with Apple
®
products (iPhones, iPads,
etc).
A
Turn on Fork 1.
B
In the device's settings, select "Search for devices"
or similar command.
C
The device will show all active bluetooth devices
available. The iForks will start with "008098" or
"Ezurio Blu2i". The last 6 characters is the Mac
address and record this.
D
Turn off Fork 1 by holding the blue battery button
until the bluetooth receiver illuminates constantly.
Release button.
E
Repeat the Steps
A
thru
D
for Fork 2.
IMPORTANT:
Shut off iFork assemblies when continuing
to Step 2.
Option 1
Option 2
Early Models
Current Models
Receiver MAC
Address Sticker
FK0298.eps
