Service and maintenance
9
92
5.
Push the metering slider against the pin, and lock it in this position by tighten-
ing the setscrew.
The end stop on the lower scale plate (metering scale) is positioned at
scale value 24. If the position does not match, the scale must be reset.
To adjust:
The metering slider is in the position of step 5 (lightly pressed against the pin).
6.
Loosen the setscrews [1] of the scale plate.
Figure 9.3:
Adjustment scale of metering slider
7.
Move the scale plate so that the
scale value 24
is exactly underneath the
pointer on the display unit. Tighten the setscrews of the scale plate.
8.
Remove the pin.
9.
Reconnect the electric cylinder or hydraulic cylinder.
10.
Hook the return spring back in position.
11.
Install the agitator, and close the service cover.
4.
Take a pin [1]
d = 25 mm
and insert it into the meter-
ing opening.
Figure 9.2:
Pin in the metering opening
1
1
Summary of Contents for 18.1
Page 30: ...Machine data 4 24...
Page 32: ...Transport without tractor 5 26...
Page 108: ...Service and maintenance 9 102...
