Rastergraf Topaz, User Manual

Page: 15 / 169

Rastergraf
General Information 1-3
Table 1-1 Board Feature Summary
Topaz
Stratus/
Garnet
Tropos/
Duros
Silicon Motion SM731 2D/3D engine with 16MB SDRAM yes yes yes
1600x1200 single VGA yes yes yes
1024x768 dual VGA yes yes no
1280x1024 single/1024x768 dual LVDS yes yes yes
1600x1200 single DVI yes yes option
S-Video/NTSC/PAL/SECAM single output yes yes Duros
Interlaced/non-interlaced, Sync-On-Green
yes yes Duros
STANAG 3350 A-C output option yes no Duros
DVI Input mode yes yes no
RGBHV, RGB, and STANAG Input modes yes yes no
S-Video/NTSC/PAL/SECAM Input modes yes yes no
Dual front panel VGA connector option yes no no
Dual VGA via DVI b/o cable option yes Stratus no
Dual VGA rear panel option yes yes no
LVDS options – front/rear yes rear only rear only
MDR26 LVDS front panel connector option yes n/a n/a
Single DVI options – front/rear yes yes yes
Composite/S-Video output
yes yes yes
MDSM-16 Video I/O connector no Stratus no
MDR20 Video I/O connector yes no no
2 Kb serial EEPROM and LM75 thermal sensor yes yes yes
3.3V & 5V PCI Bus Signaling yes yes yes
33/66 MHz PCI Bus Speed yes yes yes
CCPMC form factor compatible yes yes yes
Full CCPMC version with thermal layers no
Garnet Duros
Local 3.3V regulator yes Stratus Tropos
Side 1 only component loading yes yes yes
Field reprogrammable VGA BIOS yes yes yes
SDL Graphics Subroutine Package yes yes yes
SDL-based WindML and BIT yes yes yes
Windows 2K/XP graphics drivers yes yes yes
Windows 2K/XP video input drivers
yes yes no
Xfree86 Version 4.3 for Linux and VxWorks yes yes yes
X video in extensions for Linux and VxWorks yes yes no
RG-101 Rear I/O compatible version (PCB Rev 1) yes no no