EN
8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
·
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
·
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the cutting unit.
·
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place. Therefore, the Customer assumes the responsibility to strictly follow all the rules and
regulations in force, as well as the special provisions in force in sport and public installations
the Customer declares to know after receiving all the relative necessary information.
·
The cutting unit works also without its safety protective device. This protective
device must NEVER be removed.
·
Always check the resistance of the material to be cut and the kind of blade which is being used.
·
The Customer shall equip his own personnel with all the individual safety protections for
the execution of the works, as well as with the ones which might be prescribed by the
Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
·
Do not make any adjustment while the blade is working or while the electric plug is
connected.
·
Always pay attention to the electric cable position to prevent it from being cut or damaged
by the blade.
·
It is allowed to assemble cutting unit GRT10 on machines O.E.M. on condition that their
original structure is not modified. Otherwise, the intervention must be certified by Rasor
®
.
Firstly make sure that the lines are able to feed the cutting unit correcltly, in
compliance with the safety rules (for the feature required see par. 5).
We suggest installing a magnetothermic safety device before the cutting unit and check
that the ground circuit is effective. Before working on the feeding cable pull the plug out.
Check that electric connections and protections correspond to the driving force and the
plate data values (voltage and current), required by the different electric circuits. By referring
to the CEI 11-27/1 standard all the works carried out by means of electric current must be
performed by a staff, who has been provided with all the devices required by the above-
mentioned standard. For the works carried out under voltage, it is necessary that the
employer certifies the suitability, against formative processes.
The cutting unit GRT10 is supplied with electric cable connected
to the connector block located beside the motor. The user
must connect the cutting unit to the mains (the cable complies
with the CEI 20-22 III Standard). Never change the length of
the cable supplied. If it is necessary, use a longer cable and
replace the one supplied. To connect the new cable open the
cover “
A
” by unscrewing the 4 cross-slotted screws “
B
” (see
picture 3). Connect the phase cable to the terminal board.
The minimum section of the connecting cables must be
determined by the operator in charge of the installation.
We
recommend to use safety cables and socket IMQ approved.
Check the connection by enabling the cutting unit and verify
the rotation direction. The cutting unit is provided with earthing
WARNING
3
9. ELECTRIC CONNECTION
B
A
B
24
Enfocus Software - Customer Support
