EN
10. RESIDUAL RISKS
11. INSTALLATION AND USE
Even though the cutting unit is safe, operators must pay attention to preserve their and
other people’s safety.
L
At the end of the working operations, the motor could be very hot.
L
The cutting blade can work even when the protective device is disassembled.
To install and use the cutting unit manually, proceed as follows:
1) Fix the cutting unit on level squares or angles by means of four 5MA screws, by inserting
them in the four holes located in the motor lower cover (see pictures 4 and 5).
NOTE
The cutting unit can be installed in any position/angle: vertically, laterally and it can be turned
upside down. It is not compulsory for the Teflon base to touch the machine table.
2) Lay the material to be cut;
3) Connect the cutting unit to the electric feeding;
4) Put the material on the cutting foot;
5) Adjust the front mobile protection according to the thickness of the material to be cut (see
picture 6);
6) Carry out the cutting operation.
NOTE
Cutting unit GRT10 can work in a fixed position (the material has to be moved) or it can
move forward while the material is kept in the same position. Make sure the material to be
cut is properly stretched, preventing it from curling.
4
WARNING
Never use the two bolts which fix the motor to the cutting part to fasten cutting
unit GRT10. This operation may cause the motor shaft to break. In this case,
warranty is not valid.
5
(yellow-green cable). Possible faulty earthing connections may cause unsafe working
conditions. Possible damages are not at RASOR
®
s.r.l. charge.
The electric feeding must be supplied by a line protected against overcurrent by means of
the automatic switch (magnetothermal) or delayed fuses with a suitable dimensions. The
current of the safety devices must be as low as possible considering the max. absorption of
the machine (see identification plate).
6
WARNING
The operator must arrange a disconnetting switch on the supply line in order to switch off
the machine, if necessary.
25
Enfocus Software - Customer Support
