Raritan TZ1500, User Manual

Page: 15 / 52

C
HAPTER
2: KVM D
RAWER AND
Z-CIM I
NSTALLATION
5
Chapter 2: KVM Drawer and Z-CIM Installation
Before you begin, make sure that power to all devices you will be connecting has been turned off. To
prevent damage to your KVM Drawer due to ground potential difference, make sure that all devices
on the installation are properly grounded. Please consult your vendor for any technical issues if
necessary or contact Raritan Technical Support at (732) 764-8886 or via email at
support@raritan.com, Monday through Friday, 8:00am to 8:00pm, EST.
KVM Drawer Rack Mount Instructions
Before attaching pieces to your KVM Drawer, determine whether you will be using the short
brackets with the two-grid sliders or the longer brackets with the four-grid sliders. Select the pieces
according to the depth of the rack in which the unit will be mounted.
1. With the rear of the KVM Drawer facing you, use two screws to secure each small bracket
piece to the corners of the unit, as illustrated below.
2. Select the appropriate bracket arms and attach them to the sides of the KVM Drawer as
shown below. This bracket will fit over the small bracket piece attached in Step 1, and must
be secured with two screws from above and two screws from below.
Note : Notice that there are five openings (in the form of an “X”) at one end of
the bracket arm and there are two screws already in the KVM Drawer at two
points of the “X”; you can remove the two screws in the KVM drawer and
attach the bracket arm using five screws to fill all five holes.