Ransomes G-Plex II, Safety And Operation Manual

Page: 5 / 122

GB-3
RANSOMES G PLEX II Series :WD
SAFETY AND OPERATORS MANUAL
GB
DIESEL ENGINES
The diesel engine’s serial number is stamped into
the block directly below the injector pump (See Fig.
4).
1
Figure 4
1. Diesel Engine Serial Number
CUTTING HEAD SERIAL NUMBERS
Identification numbers for each individual cutting
head are on the nameplate decal located on the
right side panel (See Fig. 5).
NAME PLATE
DECAL
Figure 5
1. Cutting Head Nameplate Decal
IDENTIFICATION
THESE IDENTIFICATION NUMBERS MUST
APPEAR ON ALL CORRESPONDENCE
CONCERNING THIS UNIT.
MODEL NUMBER & SERIAL NUMBER
Both the Model Number and Serial Number are on
the identification nameplate decal located on the
right rear frame. See figure 1.
1
Figure 1
1. Identification Nameplate Decal
ENGINE IDENTIFICATION NUMBERS
To gain access to the engine, loosen the two hand
knobs above the rear fork.Raise the fuel tank frame
(rear section) and pivot the rod beneath the fuel
tank down and secure it in the cup next to the fork
(See Fig. 2).
DO NOT
remove fuel tank cap while
tank is in raised position.
1
2
Figure 2
Fuel Tank in Raised Position
1. Support Rod
2. Hand Knobs