Rangevision PRO, Setup And Calibration Instructions

Page: 13 / 31

Select scanning zone
After​ ​ preparatory​ ​ actions​ ​ on​ ​ setting​ ​ up​ ​ the​ ​ computer,​ ​ you​ ​ should​ ​ carry​ ​ the​ ​ scanner
setting​ ​ procedure.​ ​ Select​ ​ Configure​ ​ scanner​ ​ for​ ​ a​ ​ new​ ​ area​ ​ in​ ​ Calibration​ ​ window​ ​ on​ ​ the
Start​ ​ screen​ ​ and​ ​ follow​ ​ the​ ​ instructions​ ​ for​ ​ each​ ​ step.
Before beginning the configuration, select the desired scan area (zone), depending on
the object scanned. Scanning area is a set of interchangeable optics, calibration plate
and stand for the calibration plate, which help to configure the scanner to scan a certain
area. In the majority of cases, scan area is correctly matched, if the size of the object
approximately equals to the size calibration plate.
Calibration field parameters
Take the necessary calibration to configure the scanner to the selected scan area.
Make sure that the scan area is included in the package of your scanner.
The exact size and measurement temperature are
written on the label on the reverse side of the calibration
plate.
Enter these values into the ​ Configuration Wizard​ or
select from the drop-down list of previously entered
values.
13