Rangemaster Elite 110 Dual Fuel, User Manual

Page: 35 / 40

35
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
7 To Remove an Oven element Thermal
Cut-Out.
Disconnect from the electricity supply.
Pull the cooker forward to gain access to the cover box.
Undo the cover screws and lift clear. The cutout is located
on the earth plate beside the oven element connections.
Disconnect the cutout wiring. Undo the fixings that secure
the cutout to the earth plate and remove. Fit replacement
control and re-assemble in reverse order.
8 To Remove a Hotplate Tap
Remove the hotplate – see 2. Unplug the FSD lead from
the rear of the tap. Undo compression fitting at the rear of
the tap. Remove the fixings that secure the tap to the gas
rail. Disconnect the ignition switch wiring. Remove the tap.
Remove and discard the gasket seal. Fit new gasket seal to
replacement tap. Re-assemble in reverse order. Check the
appliance is gas sound. Check hotplate ignition.
9 To Change an Ignition Switch
Change the gas tap - see 7.
10 To Remove a Hotplate Burner Injector
Remove the hotplate - see 2. Remove the injector directly
from the burner body. Fit the appropriate injector. Re-
assemble in reverse order. Check the appliance is gas sound.
11 To Remove a Hotplate Burner Spark
Electrode
Remove the pan supports, burner heads and caps. Remove
the screw holding the electrode to the burner body. Lift up
the electrode and disconnect the lead.
Note
Take care to prevent the ignition wire from falling back
through the clearance hole.
Fit the lead to the new electrode and reassemble in reverse
order and check correct burner ignition.
12 To Remove an Oven Door
Open the oven door. Support the door and remove the two
screws that secure the upper hinge to the front frame of
the unit. Remove the door from the lower hinge by lifting
slightly and moving it outward. Re-assemble in reverse
order.
13 To Remove the Oven Outer Door Panel
Open the oven door. Remove the socket headed screws
at the sides of the door. Remove the outer door panel.
Remove the handle and fit to the new door panel. Fit the
replacement panel to the oven inner door. Re-assemble in
reverse order.
14 To Remove the Door Latch
Remove the oven outer door panel – see 12. Remove the
fixings that secure the latch assembly to the inner door
panel. Fit the replacement catch and re-assemble in reverse
order. Check correct operation of door.
15 To Remove the Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner pull seal diagonally away
from the door centre until that hook is released. Proceed to
the next hook and release it in a similar way, and so on. Use
force if the hooks are stiff, as the old seal will be discarded.
When fitting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door,
and proceed round the door snapping in each hook in turn.
16 To Adjust the Oven Door Catch Keeper
Open the oven door and slacken the locknut at the keeper
base. Adjust the keeper inward or outward as required,
until the desired door operation is obtained. Re-tighten the
locknut.
17 To Remove the Hotplate Spark
Generator
Disconnect from the electricity supply.
Pull the cooker forward to access the cover boxes at the
appliance rear. Remove the fixings that secure the cover
and lift it clear. Undo the terminal connections noting their
positions. Undo the fixings that secure the spark generator
and remove the device.
18 To Remove the Hotplate Electrode Leads
Disconnect from the electricity supply.