TTM 57SL
FOR
SERATO SCRATCH LIVE •
OPERATOR’S MANUAL
2.1
3
Important Safety InStructIonS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with manufacturer’s instructions.
8. Do not install near any heat sources such as
radiators, registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized
or grounding type plug. A polarized plug has two
blades with one wider than the other. A grounding-
type plug has two blades and a third grounding
prong. The wide blade or third prong is provided for
your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord and plug from being walked
on or pinched particularly at plugs, convenience
receptacles, and the point where it exits from the
apparatus.
11. Only use attachments & accessories specified by
Rane.
12. Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
15. The plug on the power cord is the AC mains
disconnect device and must remain readily operable.
16. This apparatus shall be connected to a mains
socket outlet with a protective earthing connection.
17. When permanently connected, an all-pole mains
switch with a contact separation of at least 3 mm
in each pole shall be incorporated in the electrical
installation of the building.
18. If rack-mounting, provide adequate ventilation.
Equipment may be located above or below this
apparatus, but some equipment (like large power
amplifiers) may cause an unacceptable amount of
hum or may generate too much heat and degrade
the performance of this apparatus.
WARNING: To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or moisture.
Apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
IntroductIon
Please read through these operating instructions
so you will know how to get the most from
your TTM 57SL and the included Scratch Live
software. Keep this manual in a safe place. If you
ever lose it, a new copy may be downloaded at
rane.com/ttm57sl.html
.
To keep up with the latest tips, and to check
for software updates for your TTM 57SL, visit the
Official Scratch Live Forum at
serato.com
.
copyrIght notIceS
© 2010 Rane Corporation. All rights reserved. Scratch
Live and the Scratch Live logo are trademarks of
Serato Audio Research. Trademarked in the U.S.
and other countries. Licensed exclusively to Rane
Corporation. This software is based in part on the
work of the Independent JPEG Group, and uses libpng
code, copyright © 2000-2002 Glenn Randers-Pehrson.
The Scratch Live Control Tone, the audio pressed on
Scratch Live Control vinyl and Control CDs, is copyright
©2004-2010 Serato Audio Research. The Control
Vinyl and Control CDs are licensed for personal use
only. The creation of personal backups of the Control
CD is allowed, however duplicating Control CDs for
commercial benefit is strictly prohibited. For avoidance
of doubt the duplication or creation of Control vinyl
for any use is strictly prohibited. Please respect our
copyright. ©2004-2010 Serato Audio Research.
Windows XP, Vista and 7 is either a registered trademark
or a trademark of Microsoft Corporation in the United
States and/or other countries. Apple, Mac, Macintosh
and iTunes are trademarks of Apple Computer, Inc.,
registered in the US and/or other countries.
WarnIng
To reduce the risk of electrical shock, do not open the
unit. No user serviceable parts inside. Refer servicing
to qualified service personnel. The symbols shown
below are internationally accepted symbols that warn
of potential hazards with electrical products.
This symbol indicates that there are
important operating and maintenance
instructions in the literature
accompanying this unit.
This symbol indicates that a dangerous
voltage constituting a risk of electric
shock is present within this unit.
mInImum SyStem requIrementS
• At least one turntable or CD player.
pc
• Windows XP with Service Pack 2 or
higher, or Vista with Service Pack 2 or
higher, or Windows 7. We recommend
Windows 7 over Vista.
• Intel processor, Pentium 4 / 1.5 GHz.
• 1 GB RAM.
• Screen resolution 1024 x 768 or higher.
• Hard drive space for storing music.
• Available USB port.
mac
• Mac OSX 10.4.11 or higher.
• 1 GHz G4.
• 1 GB RAM.
• Screen resolution 1024 x 768 or higher.
• Hard drive space for storing music.
• Available USB port.
• Scratch Live is compatible with Intel-
based Mac computers.
PLEASE NOTE: These are the minimum
requirements to run Serato Scratch
Live without optional plugins. For best
performance or when using optional
plugins we recommend you use a higher
spec computer. For more information
please visit www.serato.com/scratchlive.
CHECk LIST
These items are included with the
TTM 57SL in the box:
• Scratch Live software install disc.
• 2 (two) control CDs.
• 2 (two) control records.
• 1 USB cable.
• IEC C5 line cord.
• Package of 4 rubber feet.
• Quick Start Guide.
• This manual.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
