R&S SMCVB-K163, User Manual

Page: 47 / 92

Performing DVB-T Signal Generation Tasks
R&S
®
SMCVB-K163
47 User Manual 1179.0997.02 ─ 02
The R&S SMCV100B is connected to the local IP data network.
6. If DHCP does not assign an IP address, assign the IP address manually.
See chapter "How to Assign the IP Address" in the R&S SMCV100B user manual.
7. Specify the protocol type of the input IP data.
The current firmware supports UDP and UDP/ RTP .
To configure an external IP input signal
The R&S SMCV100B is connected to a local IP data network, see "To connect the
R&S SMCV100B to local IP data network" on page 46.
1. Specify general IP input signal properties:
a) Select "Input Signal > General > Source > External".
b) Select "Input > IP".
c) Specify the IP TS Channel, e.g. "IP TS Channel > 1".
The "IP Channel 1" side tab appears, where you can configure the IP connection
for channel 1 and channel-independent local IP network settings.
1 = IP channel notation: IP TS Channel
Configuring the Input Signal