R&S SMCVB-K163, User Manual

Page: 26 / 92

DVB-T Configuration and Settings
R&S
®
SMCVB-K163
26 User Manual 1179.0997.02 ─ 02
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:MULticast:ADDRess
on page 67
Port
Sets the destination UDP port.
Due to UDP / RTP autosensing, we recommend that you set a port offset of at least 6
between neighboring IP TS channels.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
on page 67
IGMPv3 Source Address
Requires "Type > Multicast".
Sets the IGMPv3 source address.
If you need to filter the data sent to the multicast address, specify the source address.
A source address different from "0.0.0.0" accepts only data originating from the speci-
fied IP address.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:ADDRess
on page 68
Ping Source Address
Clicking "Ping Source Address" triggers pinging of the IGMPv3 source address.
If you set a different value from "IGMPv3 Source Address = 0.0.0.0" and click the but-
ton, the software checks if the address is reachable.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:PING
on page 68
Ping Result
Displays the result after pinging the source address.
If "Ping Result > Ping: Successful", the source address is available in the network.
If "Ping Result > Ping: Transmit Failed. xxx", the source address is not available in the
network. "xxx" can be, e.g. "General Failure". Try another "IGMPv3 Source Address".
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:RESult?
on page 68
Local IP Data Network
Accesses local IP data network settings, see Chapter 4.8, "Local IP Data Network Set-
tings" , on page 43.
Input Signal Settings