R&S NRQ6, Getting Started, Page: 33 / 61

R&S NRQ6 Tour
R&S
®
NRQ6
33 Getting Started 1178.3705.02 ─ 07
Color Illumination State
Red Slow blinking Static error
Red Fast blinking Critical static error
Note: If this state occurs after a firmware
update, the update was not successful.
Further information:
●
Troubleshooting in the user manual.
5.3 LAN PoE+ Interface
See (3) in Figure 5-1 .
1 Gigabit LAN interface (1000 Base-T). The assignment of the RJ.45 CAT5 con-
nector supports twisted-pair UTP/STP cables in a star configuration (UTP stands
for "unshielded twisted pair", and STP for "shielded twisted pair").
Electromagnetic interference (EMI) can affect the measurement results. To
avoid any impact, use category 5 cables or better.
The power for the R&S NRQ6 is supplied over the LAN PoE+ interface.
The LAN PoE+ interface also connects the R&S NRQ6 to a local area network
(LAN) for remote control, remote operation and data transfer.
R&S NRQ6 requires PoE+
The electrical power for the R&S NRQ6 is provided by PoE+, power over
Ethernet. The IEEE 802.3at standard specifies 25.4 W per port. For details,
see Chapter 4.5, "Connecting to a Power Supply" , on page 18.
The power delivery at a USB host interface is not sufficient to run the
R&S
NRQ6 properly. Therefore, you cannot use it as power supply for the
R&S NRQ6.
LAN PoE+ Interface