R&S NRQ6, Getting Started, Page: 26 / 61

Preparing for Use
R&S
®
NRQ6
26 Getting Started 1178.3705.02 ─ 07
5 = USB connector
6 = Computer with installed VISA driver or R&S NRP Toolkit
7 = PoE+ injector
8 = AC supply
1. Connect the R&S NRQ6 to the signal source (DUT), see Chapter 4.4, "Con-
necting to a DUT" , on page 17.
2. Connect the R&S NRQ6 to the power supply, see Chapter 4.5, "Connecting to
a Power Supply" , on page 18.
3. Connect the R&S NRP
‑
ZKU cable cable to the host interface connector of the
R&S NRQ6:
a) Insert the screw-lock cable connector of the R&S NRP
‑
ZKU cable into the
host interface connector. Take care that the guide lug on the left side of the
host interface connector fits into the guide gap of the cable connector.
1 = Guide lug
b) To minimize the chance of cross-threading, turn the end cap counterclock-
wise until the threads of the end cap align with the threads of the connec-
tor.
c) Tighten the union nut carefully without using any force.
4. Connect the USB connector of the R&S NRP
‑
ZKU cable to the USB host.
► If you want to disconnect the cable from the host interface:
a) Loosen the union nut of the screw-lock cable connector.
b) Remove the cable.
4.6.2.2 R&S NRP
‑
Z5 Sensor Hub Setup
The R&S NRP
‑
Z5 sensor hub (high-speed USB 2.0) can host up to four R&S
NRQ6 power sensors and provides simultaneous external triggering to all con-
nected sensors. It comes with an external power supply unit, a power cable and a
USB cable.
Connecting to a Controlling Host