R&S NRQ6, Getting Started, Page: 22 / 61

Preparing for Use
R&S
®
NRQ6
22 Getting Started 1178.3705.02 ─ 07
4.6.1.3 Setup with a PoE+ Injector
PoE+ Injector
1
4
6
5
2
3
7
8
NRQ6
Frequency Selective Power Sensor
LAN PoE+
Host
Interface
Sample Clock I/O (Default: 120 MHz)
LO I/0
Figure 4-3: Setup with a PoE+ injector
1 = Signal source (DUT)
2 = R&S NRQ6
3 = RJ.45 Ethernet connector
4, 7 = RJ.45 Ethernet cable
5
= PoE+ injector
6 = AC supply
8 = Computer
1. Connect the [RF] connector of the R&S NRQ6 to the DUT, see Chapter 4.4,
"Connecting to a DUT" , on page 17.
2. Connect the RJ.45 Ethernet connector of the R&S NRQ6 to the output of the
PoE+ injector.
3. Connect the PoE+ injector to a power supply.
4. Connect the computer to the input of the PoE+ injector.
5. Establish a connection between the R&S NRQ6 and the network, see Chap-
ter 4.6.1.4, "Establishing a Connection" , on page 22.
4.6.1.4 Establishing a Connection
There are two methods to establish a network connection:
●
R&S NRQ6 and computer are connected to a common network
(infrastructure network).
●
R&S NRQ6 and computer are connected only over the switch
(peer-to-peer network).
In both cases, you can address the R&S NRQ6 as follows:
●
Chapter 4.6.1.5, "Using Hostnames" , on page 23
Connecting to a Controlling Host