R&S NRQ6, Getting Started, Page: 32 / 61

R&S NRQ6 Tour
R&S
®
NRQ6
32 Getting Started 1178.3705.02 ─ 07
5.1 RF Connector
See (1) in Figure 5-1 .
The male N connector is used to connect the R&S NRQ6 to the device under test
(DUT) or a signal generator, see Chapter 4.4, "Connecting to a DUT" ,
on page 17.
For maximum measurement accuracy, tighten the RF connector using a torque
wrench with the recommended nominal torque. For details, see
"To connect to the
DUT" on page 17.
Risk of overloading the sensor
Using the R&S NRQ6 at a level above its upper measuring limit can dam-
age the sensor head. To avoid this risk, make sure not to exceed the test
limit.
5.2 Status Information
See (2) in Figure 5-1 .
The status LED shows the state of the R&S NRQ6 by color and blinking fre-
quency.
Table 5-1: Possible states
Color Illumination State
White Steady Idle
The sensor performs no measurement and is
ready for use.
White Blinking Firmware update is in progress.
Yellow Steady Waiting for trigger state.
Green Steady Measurement is running.
Turquoise blue Steady Zeroing is in progress.
Status Information