R&S 4200 Series, Operating Manual

Page: 38 / 220

R&S XU 4200 Required Personnel
6166.5368.02.01 1.2
1.3 Required Personnel
ATTENTION
The transceiver has to be configured by qualified personnel. Installation and
operation of the transceiver should be assigned to adequately skilled
personnel.
The personnel must be familiar with this Operating Manual.
1.4 Required Power Supply
WARNING
Danger of electric shock!
The transceiver meets the requirements for Safety Class I in accordance
with DIN EN 61010-1/IEC 61010-1, e.g. all metal parts that can be touched
or accessed without removing the enclosure are connected to the protective
ground of the power supply network.
When connecting the instrument to the AC power supply, always use a
power cable with thermal connector and a socket with earthing contact.
WARNING
Danger of electric shock!
The radio contains a two-pole or neutral-conductor fuse. This means that
some parts of the radio will continue to be energized after the fuse has been
tripped.
When replacing the fuse, always disconnect the radio from the AC power
supply. Do not touch any live parts when performing service and
maintenance on the radio while the radio is switched on (by qualified
service personnel only).
External DC Power Supply\\External DC power supply "Name".doc
ATTENTION
The external DC power supply should deliver a short-circuit current of
I
≥ 30 A to ensure that the overcurrent protective device functions properly
in the event of a malfunction.
Note: To ensure that the radio works properly, it is required to supply an
earthing contact.
AC voltage The transceiver operates on an AC voltage.
When the transceiver is connected to the AC line, it automatically sets itself
to the correct voltage (AC voltage 115 V/230 V). There is no need to set the
voltage manually or change the fuse.
DC voltage The transceiver may also be powered by an external battery (28 V DC). An
automatic switchover facility integrated in the radio provides for automatic
standby switchover in case primary power fails.
Note: See chapter 2.4 for basic cabling and further information.