R&S 4200 Series, Operating Manual

Page: 147 / 220

Audio via E1 Interface (Optional) R&S XU 4200
3.95 6166.5368.02.01
3.12.2 Cabling
Instructions 1. Connect the transceiver to the E1 transmission network via connector
X13 (receiver module) only.
Cabling
Fig. 3.88 Radio operation via E1 interface.
Note: See chapter 6.2 for additional information about the E1 interface.
3.12.3 Configuration
E1 interface
configuration using
the R&S ZS 4200
Use the Service and Maintenance Tool R&S ZS 4200 to configure the E1
interface.
1. Set the “Select Audio Interface” parameter on the radio to “E1”.
2. Configure the “TX Audio ALC E1” and adjust the “TX Audio Level E1”
as required in your E1 audio infrastructure.
3. Configure the “RX Audio AGC E1” and adjust the “RX Audio Level E1”
as required in your E1 audio infrastructure.
4. Set the “E1 RAI Warning” and “E1 CRC4 ERROR Warning” parameters
as necessary for your redundancy configuration.
5. Set the “Alarm for Inactive Warning” parameter as necessary for your
redundancy configuration.
2
3
5
6
4, 7
X13
MUX
Radio
VCS
E1
Transmission
Network
RX1_RING
RX1_TIP
TX1_RING
TX1_TIP
GND