LM05 SERIES II I&M MANUAL/EN/11.30.2010
24/89
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
7
MAINTENANCE
7.1 Basic Hoist Construction
Figure 10. Basic Hoist Components
1. LOAD BLOCK ASSEMBLY (2-FALL SHOWN)
2. LOAD CHAIN
3. ELECTRICAL CONTROL ENCLOSURE
4. TOP HOOK
5. HOIST GEAR BOX ASSEMBLY
6. CHAIN CONTAINER & HARDWARE
7. HOIST BODY / MOTOR
8. LOAD HOOK SAFETY LATCH
9. FASTENER
10. PIN
7.2 Motor / Body
The hoist motors are designed to provide dependable hoisting service. The standard motors are enclosed
for IP55 rated protection against normal hazards of dust and moisture. The motor bearings are sealed and
do not require further greasing.
The hoist body is constructed of aluminum and requires no maintenance. Remove from service and replace
the hoist body if damaged.
