www.raisecom.com
User Manual
83
A.18.2 Channel Select
In Ethernet user board setting menu press number key 2 to select data channel:
Data Channel Select: Main Channel
In this status use
→
key to change the configured value: Main channel or Single channel; Press
ENTER to confirm configuration, press E key to finish configuration, and ESC to cancel
configuration.
A.18.3 Auto-negotiation Set
In Ethernet user card setting menu press number key 3:
Auto-negotiation: Enable
In this status use
→
key to change the configured value; Press ENTER to confirm configuration,
press E key to finish configuration, and ESC to cancel configuration. The configuration items are
Enable and Disable.
A.18.4 Default Port Mode
In Ethernet user card setting menu press number key 4 to set the default port mode:
Default Port Mode: Full Duplex
In this status use
→
key to change the configured value: Full duplex or Half duplex; Press ENTER to
confirm configuration, press E key to finish configuration, and ESC to cancel configuration.
Note
: Default port mode refers to the mode when Ethernet electric interface is LINK DOWN, and
when Ethernet electric interface is LINK UP it is in auto-negotiation mode.
A.18.5 Reset Ethernet Port
In Ethernet user board setting menu press number key 5 to reset the Ethernet electric interface and
the confirming prompt will be there:
To run this command will reset Ethernet port.
Run this command (Y/N):
In this status press Y to reset the board and press N to cancel the operation. Other entering are
invalid.
A.19 Double-line 10/100BaseT auto-negotiation Ethernet sub-card Setting menu
This section will explain the commands of double lines 10/100BaseT auto-negotiation Ethernet
sub-card setting menu.
