RAIS VIVA L Series, Installation & Operation Manual

Page: 32 / 55

11 / 34
INSTALLATION INSTRUCTIONS FOR OEM USE ONLY
© 2016 Mertik Maxitrol GmbH & Co. KG,
All Rights Reserved.
ON-OFF
UP
DOWN
W
all Switch
(optional)
G6R-ZWSE(N)…
Power Flue Control (not available from Mertik Maxitrol)
Receiver B6R-R8(9)P…
RECEIVER FOR POWER FLUE CONTROL, FAN, LIGHT / DIMMER, LATCHING SOLENOID, AUX (VOLT-FREE CONTACT)
Relay with Cable
(volt-free contact)
G6R-CL
40
(50
V/
0.6
A)
G6R-CLB
40
(240
V/
5
A)
Power Flue Control ▪ The receiver
has
an additional connection to start the power flue control.
▪ With
a
bistable
relay
at
the
cable
the
receiver
controls
the
start
function
of
a
Power
Flue
Control.
▪ A
Solenoid
Valve
must
be
installed
downstream
from
the
GV60.
In
case
a
2nd
burner
is
installed,
the
Solenoid V
alve has
to
close both burners. If
the
Solenoid V
alve is
installed upstream of
the
valve a pilot gas position would not be possible.
Solenoid V
alve
(Required for Power Flue Control)
Gas Combination Control GV60…
Pilot Burner G30-ZP2M
For Relay with Cable
strain reliefs
required, min. 30
N.
(to be mounted by installer)
Figure 19
▪ Power
Flue
Control,
Solenoid
Valve,
Fan
and
Pressure
Switch
are
not
available
from
Mertik
Maxitrol.
The Power Flue Control operates the Fan and the Solenoid V
alve and checks the Pres
-
sure Switch.
When
there is the required draft, the Solenoid V
alve opens. For safety
, the Solenoid
Valve must close in case of power outage. ▪ The
B6R
starts
the
Power
Flue
Control
with
the
ignition
sequence
and
when
the motor leaves
the pilot gas position and stops it at shut of
f and in pilot position.
Main Burner 1
Main Burner 2
Light
Fan
Fan
Draft Switch
Start in
Mains Power
Latching Solenoid V
alve