20
W
MINIMUM CLEARANCE
Rear V
ent
A: Side W
all to Unit
20” (508 mm)
20” (508 mm)
B: Back W
all to Unit
9” (229 mm)
10” (254 mm)
C: Corner W
all to Unit
11” (279 mm)
11” ( 279 mm)
D: Celing Height
56” (1422 mm)
56” ( 1422 mm)
E: Back W
all to V
ent Pipe
13.7” ( 349 mm)
14.7” ( 374 mm)
F: Side W
all to V
ent Pipe
25.7” ( 653 mm)
25.7” ( 653 mm)
G: Corner W
all to V
ent Pipe
19.2” ( 486 mm)
19.2” ( 486 mm)
Front W
all - Furnishing
36” ( 915 mm)
36” ( 915 mm)
A
B
E
F
C
G
C
G
D
**
8"
2"
8"
8"
16"
A
B
E
F
C
G
C
G
D
**
8"
2"
8"
8"
16"
A
B
E
F
C
G
C
G
D
**
8"
2"
8"
8"
16"
A
B
E
F
C
G
C
G
D
**
8"
2"
8"
8"
16"
Manufactured by:
RAIS A/S
Industrivej 20, DK-9900 Frederikshavn, Denmark
Rev: 5
Januar 23 - 2024
Model:
NEXO 100, 120, 140, 160, 185 USA
Solid Fuel Room Heater
, For Use With Solid W
ood Fuel Only
Emission Report no.
:
0138WS017E
Safety Report:
23-204
Model
Date of manufacture Month
Year
Serial no.
Made in Denmark
Tested to:
UL
1482-2022
Clearances to combustible surfaces
Parallel wall installation
Back wall
Side wall
Corner wall installation
Adjacent wall
Adjacent wall
** Rear/Top vent option
Ceiling
Floor Protector
FLOOR PROTECTION:
Floor protection must be non-combustible material extending beneath the stove, and to the front and sides from door opening and to the rear as indi-
cated.
The
fl oor
protection
is
not
required
to
have
thermal
protection
(R=0)
Replace glass with only Rais authorized dealer supplied ceramic glass
** Not
Tested - NFP
A Guidelines in USA,
U.S. ENVIRONMENT
AL
PROTECTION
AGENCY
Certifi
ed to comply with 2020
particulate emission standards using crib wood. 1.1 g/hr
, Method 28R
This wood heater needs
periodic
inspection
and repair for proper operation.
Consult the owner
’s manual for further information. It is against federal
regulations to operate this wood heater in a manner inconsistent with the operating instructions in the owner
’s manual.
** Non testé - NFP
A Guidelines au USA
The appliance must not be installed in a factory-built
fi replace.
See further fl
oor protection requirements
at bottom left corner of this label.
Floor protector must be under the pipe and 2”
(5cm) beyond each side for back venting.
Front
US
TECHNICAL INFORMATION
TECHNICAL INFORMATION