Raider RD-GSC03, User Manual

Page: 36 / 126

36 www.raider.bg
Faults Reasons Removal
The engine does
not start
Empty tank
Fill the tank to its full capacity; check that the
carburetor contains fuel; checking the deaeration
of the tank
Dirty air filter Clean the air filter
Low spark ignition
Clean the candle or install a new one if
necessary; check the ignition cable; the ignition
must be checked by a workshop
“Filled” engine
Unscrew the spark plug, clean it and dry it;
pull the start string several times as the candle
unfolds (no throttle)
Old fuel
Clean the carburetor, empty old gasoline and
pour new
Engine
interruptions occur
The ignition cable is loose Place the spark plug connector firmly on the
spark plug
Fuel lines are clogged or fuel is
poor
Clean the fuel line, use fresh fuel
The air inlet of the fuel tank cap is
blocked
The air inlet of the fuel tank cap is
blocked
There is water or dirt in the fuel
lines
Drain the fuel and refuel with clean and fresh
fuel
The air filter is dirty Clean the air filter
The engine
smokes a lot
Too much oil in the air filter Repeat the cleaning (see support)
The engine often
stops at idle
The ignition distance is too long,
the spark plug is defective
Adjust or replace the candle
The carburetor is not set up
correctly
Have it checked by a workshop
Dirty air filter Clean the air filter
The disc does not
work properly
Check the voltage on the handle
of the handle
If necessary, adjust the handle further
The device does not work Leave the inspection machine at a service center
Excessive
vibration
The fixing screws are loosened Tighten the retaining screws
WARNING! Faults that cannot be solved with the help of this table can be removed by an
authorized service center.If necessary, it is best to repair your aerator only by qualified specialists
at RAIDER repair shops, where only original spare parts are used. This ensures their safe operation.
28.7. Be careful not to hit the machine during transport. Do not place objects on the device.
29. FAULTS AND WAYS TO CORRECT THEM.
The table below shows symptoms of faults and how you can help yourself if your aerator stops
working properly. If you cannot find and correct the problem by following the instructions in the
table, contact a Raider Authorized Repairer. Attention! Before you start troubleshooting, stop the
aerator and unplug the aerator.