Raider RD-GSC03, User Manual

Page: 29 / 126

29
move back, first stop the blade shaft. AS YOU MOVE BACK THE COLLECTION DOES NOT WORK AND
THE MACHINE MAY BE DAMAGED.
10.1. VERTICAL CUTTING DEPTH
Push the lever up or down near the right front wheel and set the required working depth.
10.2. TO START THE ENGINE
The engine start lever (Choke switch) is located on the handle. Tilt it to the START position and
start the scarifier.
means highest engine speed means engine speed turns slower
10.2.1. Adjust the vertical cutting depth in the transport position with the lever on the right side
of the base so that the blades are above ground level when starting work.
10.2.2. The ignition is connected by a spark plug cable. Check the link.
10.2.3. Move the throttle lever to the up position.
10.2.4. Open the fuel valve (if equipped).
10.2.5. Hold the brake lever.
10.2.6. Grasp the starter handle and gently pull the starter handle until it starts to hold, then
pull it up quickly and firmly.
ATTENTION! Do not allow the starter handle to rotate against the engine. Carefully return it to
prevent damage to the starter.
10.2.7. Slowly return the starter handle to the rope guide bolt after starting the engine.
10.2.8. Set the transport lever to operating position.
10.2.9. ATTENTION! After starting the machine, move the throttle and oil switch to the position
shown in the picture: