29
Item
Points to Check
Action
Clutch and
Propeller
System
Check the propeller for bent or damaged blades
.
Check if the propeller nut is tightened and the
split pin is present.
Adjust
Replace
Dewater-
ing
Check movement of valve; inspect back valves
Check the dewatering rod Installation.
Tighten
Starter
Button
Check connections; rubber is intact
Cooling
Water
Check that cooling water is discharged from
the cooling water check port after the engine has
started.
Tools
and
Spares
Insure the BII (Emergency Kit) contains all
contents.
Steering
Check working of steering handle/tiller.
Other
Parts
Check if the anode and trim tab are securely
installed
.
Check the anode and trim tab for corrosion
Repair if
necessary
Replace
9-2 Post Mission Maintenance
•
Washing Raider with fresh water
When the engine has been used in salt water or polluted water, wash the exterior and flush the
cooling passage with fresh water. This can be done by applying “EARS” over intake.
Connect
hose to “Ears” and place over intake. Turn on Hose; start Raider 50. Water will come through
outlet port at top. Run until fuel runs out.
Place “Ears” firmly over intake
