15
d. Turn the throttle grip so that the indicator line meets the "START mark.
e. Wind the starter rope around the flywheel a few turns
.
Give
it
a sharp tug to start the engine
.
Use
a socket wrench or similar to get a firm grip on the end of the rope.
f. Warm-up
Before driving the boat, let the engine run at low speed for approximately three minutes to let it
warm and allow the oil to circulate through the machine. If the engine is not warmed up
beforehand, the engine life will shorten greatly. During the warm-up operation, confirm that cooling
water is discharged from the check port and idle port
.
5-5
4
a)
Connect the fuel connector to the engine (Figure below 5-1).
Figure 5-1. Installing hose from bladder to Raider 50.
A
CAUTION
Be careful that your clothes or other items do not get caught in
the
rope or other engine parts.
To prevent your clothes and other items from getting caught in the
engine, do not install the flywheel cover nor is the Upper Engine
Cover after the engine started with the starter rope. In this case
be
sure nobody sits in the vicinity of the engine, and run carefully.
5.4 Motor Operation Steps
