[1] Product test
- Product code and name
Qn
- Product nominal mass
Load full 1/10
- Command concerning putting subsequent products
that are numbered out of the whole charge
1/30
- Number of performed full measurements out of the
sample quantity
GROSS WEIGHINGS
COLLECTING
- Message for command „Load full”
T
- Number of errors T (Lower than Qn –T) in the sample
2T
- Number of errors 2T (Lower than Qn –2T) in the sample
Av.
- Average mass of controlled goods
OK
- Test results: OK. - positive, WRONG - negative
Test in progress
- Status
F5-End
- Description of button terminating control
NET
- Net mass of tested products
•
According to the command on the screen put on the weight pan
subsequent full or empty packages and after stabilizing press
,
•
After completing a test control different data are displayed in the
workspace (see ch. 18.7).
18.10. Estimating average tare
Users can perform the procedure of estimating average tare before starting
testing in mode „Average tare”. This procedure consist in weighing at least
10 empty packages. It is possible only if „TARE CHECKING MODULE”
is enabled in computer program KTP NET .
Procedure:
•
After selecting a product intended to be tested in mode „Average tare”
press
, and then following information data are displayed in the
display workspace:
[1] Product test
-
Product code and name for attributing a tare value
TARE
-
Present tare value
Put pack. 1/10
-
Command concerning putting subsequent products
that are numbered out of the whole sample
47
Summary of Contents for Y/KTPS Series
Page 2: ...2 JANUARY 2011...
