RADWAG AS R2, User Manual

Page: 83 / 96

- 83 -
CU1 Switch on continuous transmission in current measuring unit
CU0 Switch off continuous transmission in current measuring unit
DH Set min checkweighing threshold
UH Set max checkweighing threshold
ODH Give value of min checkweighing threshold
OUH Give value of max checkweighing threshold
SM Set mass value of a single item
TV
Set target mass value
RM
Set reference mass value
NB Give balance serial number
SS Value release
IC Internal adjustment performance
IC1 Disable automatic internal adjustment of the balance
IC0 Enable automatic internal adjustment of the balance
K1 Lock balance keypad
K0 Unlock balance keypad
OMI Give available working modes
OMS Set working mode
OMG
Give current working mode
UI Give accessible units
US Set unit
UG Give current unit
BP Activate sound signal
PC Send all implemented commands
BN Give balance type
FS Give Max capacity
RV Give program version
A
Set autozero function
EV
Set ambient conditions state
FIS
Set filter
ARS Set value release
LDS Set last digit
NT Cooperation with PUE 7.1, PUE 10 terminal
CAUTION!
Each command must end with CR LF characters;
15.2. RESPONCE FORMAT
On receipt of a command, the terminal responds as follows:
XX_A CR LF command understood and in progress
XX_D CR LF command carried out (appears only after the command XX_A)
XX_I CR LF command understood but not accessible at this moment
XX _ ^ CR LF command understood but max threshold is exceeded
XX _ v CR LF command understood but min threshold is exceeded
XX _ OK CR LF command carried out
ES_CR LF command not recognised
XX _ E CR LF
time limit exceeded while waiting for stable measurement result
(time limit is balance characteristic parameter)
Where:
XX - name of a sent command
_ - spaces