RADVision VIU-323, User Manual

Page: 96 / 129

Tips and Troubleshooting
9-6
IP Address Problems
If you experience difficulty setting the VIU-323 IP address parameters (IP address, default
router IP address and IP subnet mask) using the OnLAN Config 323 system configuration
software, an alternate method is to connect the configuration PC to the VIU-323 console
(serial) port and run a terminal session. After the terminal session, run OnLAN Config 323
to define the other VIU-323 parameters.
Defining IP Addresses via a Terminal Session
"
To establish a terminal session between a PC and the VIU-323
Note: The VIU-323 and configuration PC do not have to be disconnected from the LAN.
1. Make sure the VIU-323 is turned off.
2. Connect the 9-pin male connector of the null modem cable to the console (serial) port
on the front panel of the VIU-323 and connect the cable’s nine-pin female connector to
the configuration PC’s COM 1 port (alternately, you can connect the cable’s 25-pin
male connector to the PC’s COM 2 port, but this may require a female/female adapter).
3. Use Windows HyperTerminal™ or a similar application to open a console session. Set
the following parameters for Windows HyperTerminal:
! Port Settings:
Rate=9600
Data bits=8
Parity=none
Stop bits=1
Flow control=none
! Properties:
Function, arrow, and Ctrl keys act as=Terminal keys
Emulation=ANSI
Backscroll buffer lines=500
! Terminal Setup:
Underline=enabled
Blink=enabled
! ASCII Setup:
Wrap lines that exceed terminal width=enabled