Managing Calls and Videoconferences | 42
RADVISION | User Guide for SCOPIA XT5000 Series Version 3.0
By default, the total available bandwidth is evenly divided between live video and presentation.
In most cases it ensures the best content sharing experience. If necessary, your system can change
the bandwidth dedicated to live video and presentation to suite your network requirements.
Before You Begin
Before sharing content, proceed as follows:
•
Configure your computer to the resolution and refresh rates supported by the system. See
Selecting the Computer Display Resolution page 27
for detailed information.
•
Connect your computer to the DVI-I connector of the XT Codec Unit. See the Quick Setup
Guide for installation instructions.
•
Check the audio settings.
To hear the PC input locally and remotely, you need to route PC audio through the digital
audio port.
Navigate to Administrator settings > I/O connections > Audio - Inputs > Digital audio/HD
page. Select Digital audio associated with DVI or Digital audio always.
Navigate to Administrator settings > I/O connections > Audio - Outputs > General page. In
the Digital audio/HD camera to output field, select All or HD1+Digital audio.
Procedure
Step 1
In the Main Menu page select Make your call.
Step 2
Press
to share the presentation.
Step 3
To end the presentation, press
.
Note:
If you are not in a call, you can share your presentation with participants in the local
conference room. See
Sharing Content in the Local Conference Room page 40
Blocking Video From the SCOPIA XT Series
While in a call, you can block video from your local SCOPIA XT Series. Press
on the XT Remote
Control Unit. The system sends a pre-defined image to the remote endpoint. The
icon
appears on your display, indicating that the remote endpoint no longer receives video from your
local endpoint.
You can configure your SCOPIA XT Series to block video input from your local endpoint by default
at the start of each call. For more information see
“Configuring the SCOPIA XT Series to Block Its
Video Input by Default” on page 22
.
