You can also switch between
ABC
,
abc
, and
123
input methods by pressing
1/a/A
repeatedly
while the cursor is in the input field.
Pairing an XT Remote Control Unit with a XT Codec Unit
About this task
Perform this procedure if there are multiple Scopia XT Executive endpoints in the same room.
Each XT Remote Control Unit is dedicated to one XT Codec Unit by pairing them. This is done by
configuring the same numeric code in your XT Remote Control Unit and the system software.
An XT Remote Control Unit is configured with code 01 by default.
Before you begin
Decide what numeric code you want to use for your monitor and the XT Codec Unit. You can choose
any value between 1-99.
Procedure
1. Access the general settings, as follows:
• From the web interface, select
Basic Settings > General
.
• From the endpoint's Main menu, select
Configure > General
.
Figure 13: Setting the XT Remote Control Unit Code
2. Enter the numeric code in the
Remote control code
field. You can choose any value
between 1-99.
3. From the web interface only, select
Save
.
User Guide for Scopia XT Executive Version 3.2
Getting Started | 23
