46
Symptom
Cause
Suggestion
The TAD does not record
caller’s messages.
The incoming message
tape is full.
Delete calls from the incom-
ing message tape, or turn
the tape over and record on
the other side, or rewind the
tape and record over any
old messages you don’t
want to save.
The TAD records a dial
tone, beeping, or the opera-
tor’s voice instead of the
caller’s message.
A caller hung up without
leaving a message or with-
out using the maximum
time, and the TAD didn’t
detect 7 seconds of silence.
Set CPC to MIN.
Recordings sound distort-
ed.
• Tape heads are dirty.
• Clean the tape heads
(see “Cleaning the
Tape-Handling Parts”
on Page 49).
• The tape is worn out.
• Replace the tape.
You cannot operate the
TAD remotely.
• The tone output from
the phone or tone dial-
er is not long enough.
• Use another phone or
tone dialer.
• You are using a rotary-
dial phone.
• Use a touch-tone
phone or pocket dialer.
• You did not correctly
enter the remote oper-
ation security code.
• Try entering the secu-
rity code again. Enter
the security code
within 5 seconds, and
make sure each but-
ton press is at least
1
/
2
second long.
• You didn’t enter a
remote command with-
in 30 seconds after the
command prompt. The
TAD beeped and hung
up.
• Redial and try again.
43-738.fm Page 46 Friday, August 13, 1999 1:51 PM
