16
3. Press
then
MEMORY
on the
handset. The HOLD/INT indicator
on the handset blinks and a long
beep sounds.
4. Within 30 seconds, press
FLASH
then
#
on the handset.
Note: If you do not press
FLASH
and
#
within 30 seconds, the
HOLD/INT indicator on the hand-
set turns off and the handset
beeps twice. Repeat this proce-
dure from Step 3.
5. Press
MEMORY
on the handset to
store the new setting. The HOLD/
INT indicator turns off and a long
beep sounds.
To restore the quick call function, re-
peat Steps 1-5, but press
instead of
#
in Step 4.
CHANGING CHANNELS
To reduce interference and get the
clearest communications between the
base and handset, you can change the
channel the phone is using. The phone
uses one of 25 channels when you
hear a dial tone or during a call. When
you press
CHANNEL
, the phone auto-
matically changes to another channel
and uses that one.
Notes:
• Since unwanted noise usually
affects more than one consecutive
channel, the phone does not tune
to the next consecutive channel
when you press
CHANNEL
.
• Either the TALK or HOLD/INT indi-
cator on the handset must be on
to change the channel.
• If the handset is too far from the
base, the phone might not change
channels. Move closer to the base
and try again.
USING FLASH
Pressing
FLASH
sends the electronic
equivalent of a switchhook signal. Use
FLASH
with special phone company
services such as call waiting.
If you have call waiting, you can press
FLASH
to take an incoming call without
disconnecting the current call. Press
FLASH
again to return to the first call.
43-738.fm Page 16 Friday, August 13, 1999 1:51 PM
