To set contact inputs for the
run-time meter
function, program each channel as follows:
5 ZZ 4 ENTER
Initial Testing
Perform the following steps to ensure that your Verbatim autodialer is properly installed:
1. First, temporarily disarm the unit by pressing: DISARM/RE-ARM until the
DISARM LED is flashing. This prevents the unit from dialing out.
2. Next, physically trip each sensing device in turn (manipulate float switches,
relays, etc.). Verify that the corresponding input channel LED lights at the front
panel, and then restore all sensors to their normal state.
3. Now press DISARM/RE-ARM. This will clear out the channel input LEDs and
restore the unit to a ready condition.
4. To test the phone line connection, with the unit’s phone cord plugged into its
phone jack, temporarily remove the AC power cord to the unit. The PFAIL LED
will illuminate. At this point all illuminated LEDs will flash on and off in order to
conserve battery power. Since the unit is not disarmed this time, after a 0.1
minute Alarm Trip Delay the PHONING light will illuminate and the unit will
access the phone line and will begin dialing the first phone number. The unit will
recite its station ID and power failure messages. You may converse with the
person answering by pressing and releasing DIALOUT/ PRESS TO TALK. Press
this key again when you wish to speak, and release this key to listen. This action
will suspend message recital. In this case, when the conversation is done, you
should end the call by pressing NORMAL. Ordinarily the alarm call would end
automatically.
