Racelogic Ltd
Lap Timing Mode
Page
24
Split Output
Similar to the Laptime Telemetry option, this enables split time data or a 250ms pulse to
be output via the telemetry serial port whenever a split line is crossed. The output given
will be the same type as the lap timing output, so if you have enabled Laptime Telemetry
the split output will be in the Telemetry format; if you have enabled Laptime Pulse the split
output will be in the Laptime Pulse format. If this option is disabled, no output will be given.
Start / finish and split lines
Before DriftBox can measure and display times, you will need to either load previously
recorded start / finish lines or create new ones in your DriftBox.
Setting start / finish lines
•
Press the
MENU
button to display the Lap Timing Menu.
•
Highlight ‘SET START & SPLITS’ and press
OK
•
As you drive across the start / finish line press
OK
•
This will set the start / finish line and the screen will now show the SET SPLIT1
screen.
•
To set the first Split, press
OK
when you pass this point or press
RESET
to skip.
•
If you wish just to place a separate Finish line, press the ‘
RESET’
button to skip all
the split points and scroll to the SET 2
nd
FINISH screen.
•
Press
OK
to set a separate finish line as you drive over it.
Note: you must be moving to be able to set virtual lines.
Saving start / finish and Split Lines
After creating start / finish, Splits or Finish lines you can save them to a file on the SD card
which can be loaded back into DriftBox at a later stage, or used in the DriftBox Tools
software. The file created on the SD card is an ‘.dsf’ file.
To Save the lines you have created:
•
Ensure the SD card is inserted.
