Racal Instruments 3155, User Manual

Page: 88 / 202

User Manual 3155
3-36 ArbConnection
Figure 3-44, An Example of Generating Sine Waveforms From the Built-in Library.
Creating Sine Waveforms
Use the following procedure to create sine waveforms from the built-
in library. Click on Wave, then sine… the dialog box as shown in Fig-
ure 3-15 appears. You can now start programming the parameters
available in this box.
Start Point – Defines the start point of the created sine. Note that if
you change the start point the left anchor automatically adjusts itself
to the selected start point. The example shows the start point set at
point 0.
End Point – Defines where the created waveform ends. Note that as
you change the end point the right anchor automatically adjusts itself
to the selected end point. The example shows the end point set at
point 499.
Cycles – The Cycles parameter defines how many sine cycles will
be created within the specified start and end points. The example
below shows five cubic sine cycles.
Waveform Amplitude – 14-bits of vertical resolution define 16,384