- 33 -
O
PERATOR
'
S
MANUAL
KORMORAN SF 180 / SF HA 180
9901.00.07EN04SF - 02/2017
6XEMHFWWRWHFKQLFDOPRGL¿FDWLRQV
Adjust the cranked lever end stop
1
2
4
3
Legend
1 Link
arm
2 Shoe
bearings
3 Cranked
lever
4 End
stop
ʈ
7KHUHPXVWDOZD\VEHDJDSEHWZHHQWKHFUDQNHGOHYHU
DQGWKHHQGVWRSVRWKDWWKHOLQNDUPFDQUHVWWLJKW
DJDLQVWWKHVKRHEHDULQJV
ʈ
The angular stop is adjusted at a system pressure of 120 bar
VHHFKDSWHU
ʈ
7KHGLVWDQFHEHWZHHQWKHFUDQNHGOHYHUDQGWKHHQGVWRS
VKRXOGEHDSSUR[PP
5
6
Adjustment
ʈ
Lower the hydraulic pressure.
ʈ
Undo the SW 36 mm lock nut (
5
ʈ
Adjust the distance by turning the SW 36 mm adjusting screw
(
6
Turning the screw clockwise = increases the distance
Turning the screw anti-clockwise = reduces the distance
ʈ
Tighten the lock nut.
7.5
Offset adjustment (width of 1
st
furrow)
1
2
Legend
1 Offset
open
2 Offset
closed
When working, the offset must be open in such a way that the 1st
body works the same width as the other bodies of the implement.
The offset adjustment varies according to the tractor used.
-
Minimum distance between the inside faces of the rear tyres:
1.30 m
-
Maximum distance between the inside faces of the rear tyres:
1.60 m
IMPORTANT:
The offset allows the 1
st
furrow to be completely
suppressed up to a rear tyre inner spacing of 1.40 m.
1
Legend
1 Wear
plate
IMPORTANT:
The wear plates (1) can be replaced if there is
excessive play in the slides. Contact your dealer.
