STEALTH-IN-1114
1.
Attach the Universal Mounting bar with the screws provided to the junc-
tion box. If you are attaching your STL360 kit to a surface mount weath-
erproof box, you must use with the metal mouting plate with gasket.
2.
Easy Wiring Tip:
Use the “S” shaped Hands
Free Hanging Hook to hold
the CU4 EZ Plate during wiring.
3.
Bring power leads and sensor
kit leads through holes in
gasket and plate into
junction box.
4.
Strip 1/2” of insulation from
all leads.
5.
Attach ground wire(s) to junction box grounding screw.
Connect as shown in wiring diagram on page 7.
6.
Twist on wire nuts. Secure with electrical tape.
7.
Align CU4 EZ Plate and metal surface plate with gasket (for use with
surface mounted junction boxes) to ensure proper seal. Tighten CU4 EZ
Plate center screw (make sure O-Ring gasket is on the screw) to attach
CU4 EZ Plate to the box.
8.
Insert plastic Finishing Cap in the center of the CU4 EZ Plate for a weath-
erproof seal.
9.
Use silicone sealant around plate and all opening to ensure a weather
proof seal. Seal all unsued conduit entries on surface junction box.
10.
Screw in light bulbs. Turn on power. Conduct walk test to adjust
sensor response (see page 15).
STL360HBW
STL360H
Insert
close-up
plug in
unused
hole
Finishing
Cap
Bar Screws
Gasket &
Surface Plate
Universal
Mounting
Bar
Hook
O-Ring
Gasket
CU4 EZ Plate
Gasket
Center
Screw
Black
Black
Red
Red
(pigtail)
Ground
Ground
Power In
White
White
Mounting
STL360 Kit Assembly and Wiring
STL360 floodlight kits come pre-wired and assemble on the RAB CU4 EZ
plate, allowing for mounting on round, rectangular or octagonal surface or
recessed boxes.
Wiring
Red pigtail is only used to switch
remote or additional fixtures.
Hood rests
in notch on
crossbar
Hands Free
Hanging
Hook
CU4 EZ Plate
7
8
