GRB-200 Demodulator (GOES-R) OI&M
GRB-200 Demodulator (GOES-R) OI&M
© Copyright 2015, Quorum Communications, Inc.
29
Revision A.01
Set the Demodulators (My) IP Address
Continue to press the top switch to set the TO IP Address and after the last
digit the display will switch to display MY IP. The message “Demodulator IP
Address” will briefly be displayed followed by the display below.
Figure 22 - Demodulators IP Address Screenshot
As with the TO IP Address above, press the bottom switch to cycle through the
address digits displayed above the caret symbol and press the top switch to
move to the next digit. Setup is aware of valid addresses and will allow you to
set this to any valid IPv4 address.
Continue to press the top switch to set all digits.
If you don’t want to change this address, just continue to press the top switch
past all of the digits to get to the next setting.
If MY IP Address has been changed the message “Setting MY IP Addr” will
be displayed and a brief delay will occur while the Demodulator IP Address is
changed in the Linux Data Processing Sub-system.
After setting the MY IP Address, you will be given the option to exit or press
the top switch to go to the start of setup.
You can exit setup at any time by pressing and holding the top switch.
