GRB-200 Demodulator (GOES-R) OI&M
GRB-200 Demodulator (GOES-R) OI&M
© Copyright 2015, Quorum Communications, Inc.
23
Revision A.01
Entering Setup Mode to Configure the Demodulator
Pressing and holding the top switch will display “Hold for Setup”. Continuing
to press the top switch after a few seconds will display “Release for Setup
Mode”. Releasing the top switch at this message will enter Setup Mode where
the demodulator configuration can be changed. If you release the top switch
before the release message displays, setup mode will be cancelled.
Once in setup mode, pressing the bottom switch will cycle through the possible
options for the displayed mode or increment the number above the caret
symbol. Pressing the top switch will move to the next option or digit in a
number.
Setup mode can be exited by choosing exit when the option is presented in the
display, by pressing and holding the top switch for a few seconds at any time
or timing out after 45 seconds of no activity.
LCD Display
3.1.3
Figure 16 - LCD Display
During normal operation the 2 line LCD alternately displays the received
signal level, lock status and Es/No (signal quality) of the LHCP and RHCP IF
inputs. Alternate data is displayed here when in status, diagnostic or setup
mode.
