quiko Swingy QK-SW80, User Manual

Page: 6 / 20

Installation Instruction
6
Automatism assembly
WARNING : Before proceeding with the installation, remove the 2 cardboard components positioned underneath the
motor body.
Positioning dimensions (rigid pull arm - QK-SW80PULL)
The rigid pull arm is used when the automatism is installed on the swing side of the door.
WARNING : For a correct positioning, always use the main axis of the wing hinges and the operation axis of the gear-
motor as a reference, as shown in Fig.5.
220
150 600
29
SWINGY fastening diagram 1 left-hand opening wing Rigid Pull Arm
Gearmotor Axis
Hinge axis
Rigid pull arm
Aluminium guide
Fig. 5
For right-hand opening
wings (anticlockwise direc-
tion), the assembly of the
automatism perfectly mir-
rors the left-hand opening
assembly.
Rigid pull arm
Aluminium guide
Gearmotor Axis
OPENING
DIRECTION
Fig. 6
WARNING : The final tighte-
ning of the screws must be perfor-
med only after having checked
that the vertical positioning of the
automatism guarantees a good
parallelism between the hinge axis
and the gearmotor axis. For this
purpose, the rigid pull arm and
relative guide must be installed,
check that the pin coupling the
arm to the cylindrical slide is not
strained during operation.
An error in the position of the auto-
matism may, in fact, cause the pin
of the rigid arm to oscillate with
respect to the cylindrical slide to a
degree beyond the allowed tole-
rance, with consequent damage to
one of the automatism parts.
35
102
76
9
29
47
9
52
QKSW80