14
13.1 Steps of removing the Heater
1) Pull out the
①
Soldering tip and screw down the
⑤
Nipple;
2) Pull out the
⑥
Heater from the
⑪
Handle body;
3) Pull out the
⑩
Wire clamp from the
⑨
Plastic part upward;
4) Unplug the three leads plugged into the heater pin;
5) Remove the
⑨
Plastic part,
⑧
Spring and
⑦
Grounding spring .
Note: All operating steps are performed with the power disconnected and the handle
cooled.
13.2 Steps of replacing the Heater
1) Plug the three wires into the
⑥
Heater pins;
2) Install the
⑧
Spring and the
⑦
Grounding spring, and snap the
⑩
Wire clamp into the
⑨
Plastic part;
3) Put
⑥
Heater into
⑪
Handle body;
4) Screw on
⑤
Nipple and Install
①
Soldering tip;
5) Put
②
Tip enclosure and
③
Nut on
⑤
Nipple and screw them tightly;
6) After replacing the heater, the following measurements are recommended:
7) Calibrate the temperature, refer to Soldering temperature calibration.
