9
Adjust the knob clockwise to increase the airflow, and otherwise decrease the airflow.
The hot handle sleeping
Place the handle on the holder to start cooling air and the product enters sleeping mode.
8.Password Setup
The initial password is "000", and in this state, you can set the temperature. If you need to
limit the temperature adjustment, you must change the password.
Enter password setting mode
1) Turn off the system, press the "▲" and "▼" buttons at the same time, and then turn on
the system.
2) Press and hold the "▲" and "▼" buttons, C will be displayed after a beep, and the "---"
display will pop up on the interface.
3) After entering the correct password, go to parameter setting.
Enter the initial password
1) The window shows "- - -" and the leftmost digit flashes, at this time the digit can be
adjusted (i.e. enter the initial password).
2) Enter the initial password: adjust the middle knob to change the hundreds’ digit, press the
"▲" button to move the digit, and then the tens’ digit will start flashing to be set, and the
tens’ and units’ digit will be set in the same way as the hundreds’ digit. When the digit is set,
press and hold the "
▲
" and "
▼
" button at the same time to confirm.
3)
If the first password is wrong:
then directly enter the second password, and the input
way is the same. (There are two chances of password input. If the first password is wrong,
