6
7
INSTALLING VENTILATION - CHILLER UNIT
CONNECTING WATER SUPPLY
Ventilation will ensure your chiller performs to
its specifications. Failure to install this will void
the warranty on this module.
1. Inside the packing, you will find cutting tem-
plates. Choose the CS20 base and front grill.
2. Drop the kick board and check underneath
the cupboard’s left side for any pipes or electri-
cal wires that may be in the way.
Ensure they are moved before starting to cut
the ventilation.
3. Locate the base cutting template inside the
cupboard’s left side, mark the 4 corners, and
cut the ventilation hole into the base.
4. Install the vent kit (steel angle piece) provid-
ed and insert the vent duct so that it runs to the
front of the cupboard. Mark off the point where
it crosses the kickboard and cut to length using
a suitable hand saw.
5. Using the template for the kick board vent
grill, mark the location for the screws and cut
out area and cut out.
1. Connect your cold water supply using the 1/4”
(6.35mm) blue tubing that is supplied in the kit.
Connect it to the right side of the boiler.
2. Connect the blue ¼”(6.35mm) tube found in
the installation kit to this ¼” (6.35mm) connec-
tion on the mains supply (push in firmly), then
cut it at a length that extends to the front of the
cupboard where the water heater inlet will sit.
3. In the fitting kit, you will find a 1/4” (6.35mm)
filter screen. Fit this in the same line to the boil-
er to protect the inlet solenoid from particles
that can stop it from closing.
*Illustration next page
4. Slide the QST553-B (the water heater) into
the place on the right side of the cupboard.
Connect the ¼” (6.35mm) pipe from the isola-
tor into the front right-hand side port.
5. Now
(1)
turn on the cold water supply and
(2)
turn on the isolator, check the connections are
water-tight.
DO NOT PLUG IN THE WATER HEATER UNTIL
INSTRUCTED TO DO SO.
6. Fix grill to front and
replace the kick board
so that it marries up
with the vent duct.
SECTION FOUR
INSTALLING THE VENTILATION
FOR THE CHILLER UNIT
SECTION FIVE
CONNECTING WATER SUPPLY
6. In your installation kit, you will find a length of
silicone tube with a VenturiT™ connector. Con-
nect the shortest distance (above the T) to ei-
ther of the two (2) pipes protruding from the
base of the faucet, using the spring clips to se-
cure the tubing.
When pushing the silicon onto the tap stem
avoid pulling these down onto the silicon. Be
sure to push up onto the stems or they will be-
come dislodged from the spout tip.
