Introduction to the CB-620x IP Bullet Camera
7
3.
Seal the end of the rubber coating of the system cable as indicated in the figure below. Use
enough silicone gel to fill in the hose and wrap around each wire in order to properly
waterproof the cable.
Figure 8: System Cable Hose and Wiring
3.4.1.2
RJ45 Cable
To waterproof the RJ45 cable
1.
Plug the Ethernet cable to the connector of the RJ45 cable.
Figure 9: RJ45 Connector and Plug
2.
Coat the joint with silicone gel. Make sure there is no gap between the Ethernet cable and
the connector in order to properly waterproof the cable.
3.4.1.3
IP66-Rated RJ45 Cable
To waterproof the IP66-Rated RJ45 cable
1.
Remove the supplied connector from the IP66-rated RJ45 plug.
Figure 10: Thread-Lock Sealing Nut and RJ45 Connector
2.
Loosen the thread-lock sealing nut on the IP66-rated RJ45 plug.
Figure 11: Loosened Thread-Lock Sealing Nut
