Quark-elec Manual
https://www.quark-elec.com
25 of 30
2018
V2
Note: The local time will not be affected by
switching off the timer.
Monitoring/alarm input
Releases
relay
status
which is triggered by the
external signals.
EXTRT
After it has been triggered by the external
signals, the related relay will be locked in the
normal state. By sending
„EXTRT‟
, the relays
will be unlocked and available for responding to
SMS commands again.
Disable the function of
been
triggered
by
external signals.
EXTGBn
n=1, Relay 1
n=2, Relay 2
n=3, only available for
PIRwireless PIR detector
(G022P variant)
By sending
„EXTGBn‟
, the external alarm input
n will be disabled. Message „Alarm input n has
been disabled.
‟ will be returned to the operator
if the setting is successful, where n is „1‟
„2‟or‟3‟.
By sending „
EXTRT
‟ all external alarm inputs
will be active.
This disable status
isn‟t achievable by re-
powering up the module, only
„EXTRT‟
will re-
enable the external alarm input.
G022P has two digital input ports which can be used to monitor external signals. These two external input
ports can accept 0 V to 24 V voltage levels. Should the input voltage level be below 1.0 V, the main mobile
terminal will receive the warning message „Port n has been triggered‟, where n is the relay number. The
relay n will switch to the normal state (NC will be the closed state and NO will be the open state). Sending
„EXTRT‟ will release the relays and make them available for responding to SMS commands.
