Quark-elec Manual
https://www.quark-elec.com
3 of 30
2018
V2
1. Set up overview
You will need:
SIM card:
The SIM must operate on the GSM (2G) network.
Most network providers provide 2G cover, check
with your supplier.
Credit on the SIM (we recommend automatic top-ups)
The SIM is not PIN protected
The SIM is set to disable voicemail
Avoid SIM cards that deactivate automatically if the SIM is not used often
(If your SIM will do this
and if your G022P is likely to be unused for long periods of time you will have to send the G022P an
update request periodically to keep the SIM card active.)
Power supply cable:
make sure it is long enough to reach your device in its final location.
Check there is mobile network reception for your SIM card
in the location that your device will be installed
(you can check by putting the SIM card in a mobile phone)
Installation:
1. Download and install the app
for mobile phones. https://www.quark-elec.com/downloads/apps/
2. Select G022P location:
location must be indoors and not exposed to water or high humidity.
3. Connect the relay output (if required):
check relay setup for whether you want relays in normal open (NR) or
normal closed (NC) position. Think about length of wires needed to connect.
4. Connect alarm inputs (if required):
alarm inputs must send signal as switches closing circuit to input 1/2 or by
sending low voltage signal to input 1/2. Think about length of wires needed to connect.
5. Insert your SIM into the G022P device (make a note of the SIM number first for reference)
6. Connect to power:
Check LEDs are working correctly.
Red LED
: will flash at 1 second intervals once the system has finished initialization. It will then flash every time it is
operating a command
Blue LED
: LED will flash blue at start up as it looks for a network signal. Once a signal has been found the LED will
flash much slower, every 3 seconds.
7. Register the main phone number that will control the device within 10 minutes of powering up the
G021/22.
Register the main mobile terminal with G022P module
by texting „
88888888
‟ from your chosen phone to
G022P
SIM card. If registration is successful, the module will reply with “
Your phone has been registered
”. If
unsuccessful, the module will reply with
„
registered d
isabled‟
. If registration is unsuccessful, restart the device
and reattempt registration within 10 minutes of powering up the device.
The network LED will flash after registration is completed. You can add up to 3 secondary control mobile phones
using text/APP codes (check the manual for full list of text codes).
8. You can now send commands and receive messages either by text or through the text generating APP.
Remember; the device processes one command at a time. Each command will have a reply to confirm the
command has been received and executed. You must wait for a reply message before sending another command.
If G022P (PIR version):
Batteries:
the PIR device uses a 9.0 volt D-shape battery.
Location:
Think about location of sensor and whether there is anything in between the PIR sensor and the
G021/22. Some obstructions will make the signal weaker for example metal structures and concrete walls.
(This is an overview only. Familiarize yourself with the manual before installation.)
